Table of Contents
Advertisement
3
Install the mounting plate.
3a Route wire through slot. Secure with mounting
screws.
Actual Size
4
Find and record Programming and User Codes.
The default Programming Code and two User Codes are
printed on a sticker on the back of the printed Quick Start
Guide. It is also on the inside assembly. You will need the
code for the setup procedure after the lock is installed.
The HomeKit sticker is located on the front of the inside
assembly and on the back of the printed Quick Start Guide.
save this guide!
These are your default codes.
PLACE LABEL
HERE
You will need these codes if you ever factory
default reset your lock. Keep these safe!
PLACE LABEL
HERE
© Allegion 2018
Printed in U.S.A.
P518-415
P518-415 Rev. 02/18-b
5
Install the inside assembly.
5a Remove battery cover.
5b Connect cable from outside touchscreen to the
connector on the inside assembly.
5c Press inside assembly onto the mounting plate.
The bump on the tailpiece
aligns with the slot in the
back of the inside assembly.
If it does not line up, make
sure the thumbturn is
vertical.
Hide quick links:
Advertisement
Table of Contents
