Table of Contents
Advertisement
RUGGEDCOM MX5000
Installation Guide
1.
Place the device against the panel and align the adapters with the mounting holes.
Figure 5: Panel Mounting
1. Screw 2. Adapter
2.
Install the supplied screws to secure the adapters to the panel. Make sure the screws are torqued to 2 ± 0.1
N·m (18 ± 1 lbf-in)
Section 2.4
Installing the Chassis Ground Connection
If the ground terminal on the power supply module(s) is not connected to safety Earth, a connection must be
provided from the chassis ground terminal on the RUGGEDCOM MX5000 chassis.
IMPORTANT!
If the ground terminal on the power supply module(s) is connected to safety Earth, a connection from
the chassis ground terminal is not required.
1.
Position the grounding cable and external tooth lock washer on the RUGGEDCOM MX5000.
Installing the Chassis Ground Connection
2
2
Installing the Device
1
Chapter 2
11
Advertisement
Table of Contents
