Setting The Clock; Sleep Timer Setting; Dimmer - LG CM4730 Owner's Manual

Setting the Clock

1. Turn the unit on.
2. Press CLOCK.
3. Choose time mode by pressing Y/U.
- AM 12:00 (for an AM and PM display)
or 0:00 (for a 24 hour display)
4. Press SET to confirm your selection.
5. Select the hours by pressing Y/U.
6. Press SET.
7. Select the minutes by pressing Y/U.
8. Press SET.
9. If you want to reset the clock, press and hlod
CLOCK. Then repeat steps 2-8.
Setting the alarm
You can use the unit as an alarm clock.
You have to set the clock before setting the alarm.
1. Turn the unit on.
2. Press TIMER.
3. Each of functions will blink. Press SET to select a
sound source you want.
4. "ON TIME" will be displayed. This is your desired
time to the unit turns on. Press Y/U to
change the hours and minutes and press
SET to save.
5. The "OFF TIME" will be displayed. This is your
desired time to the unit turns off. Press Y/
U to change the hours and minutes and
press SET to save.
6. Press Y/U to change the volume and
press SET to save. The clock icon "(" shows
that the alarm is set.
7. Press TIMER. You can check the setting status.
8. If you want to reset the alarm, press and hlod
TIMER. Then repeat steps 3-6.
CM4730-AU.DCOLLLK ENG 0490.indd 19 CM4730-AU.DCOLLLK ENG 0490.indd 19

Sleep Timer Setting

Press SLEEP on the remote control repeatedly to
select delay time between 10 and 180 minutes.
After delay time, the unit will turn off . (You can see
the following order, 180 ->150 -> 120 -> 90 -> 80
-> 70 -> 60 -> 50 -> 40 -> 30 -> 20 -> 10). To cancel
the sleep function, press SLEEP repeatedly until the
display window get bright.
,
Note
• Press SLEEP. The remaining time appears in
the display window.
• Sleep function will work after dimmer
function.

Dimmer

Press SLEEP once. The display window will
be darkened by half. To cancel it, press SLEEP
repeatedly until the display window get bright.
,
Note
• After setting a clock function, you can set
alarm function.
• If you set the clock and alarm, you can check
the time and alarm icon "(" by pressing
CLOCK although the unit is turned off .
• During playback, press TIMER two times
when the alarm icon "(" is displayed. You
can check the setting state.
• If you activate the alarm, the alarm icon "("
will appear in the display window.
• If you deactivate the alarm, the alarm icon
"(" will disappear in the display window.
• Alarm function only works when the unit is
turned off .
• If the time you set is up, the unit will be
turned on automatically.
Operating 19
3
2013-04-19 2013-04-19 2:43:13 2:43:13