Operation - AcraDyne AAP1B66400A Operation Manual

CAUTION IS REQUIRED. FAILURE TO EXERCISE CAUTION AND CORRECT OPERATING
TECHNIQUE CAN RESULT IN SERIOUS PERSONAL INJURY, LOSS OF LIMB OR DEATH.
AcraDyne HT Series Nutrunners are a part of a system including the AFRL-4HTA, Air hose and Tool.
®
High Torque Pneumatic Series
1. Connect the Air Hose to the tool's Air Inlet:
Use proper size Air Hose and connector to supply proper air pressure and CFM to tool.
2. Reverse Lever:
"R" is right-hand roation and "L" is left-hand rotation.
3.
Trigger Button Operation:
Engage fully to supply full air pressure to air motor.
4. Directional Exhaust
Direct exhaust away from the operator, co-worker and workpiece.
Each AcraDyne HT Air tool is delivered with a Pressure versus Torque Output Calibration Graph (See example).
Calibration Graph (See example). Using a reliable regulator with gauge in the air supply line, adjust the supply air pressure to correlate
with the desired torque output as shown on the specific graph supplied with the tool. Pressure value should be observed and
confirmed with the tool trigger depressed and the tool free running.

Operation

Torque Adjustment
5
High Torque, High Speed Pneumatic Series