Mitsubishi Electric MES3-255C-DM-EN User Manual page 11

Front
(with power supply cover opened)
Bottom
Battery storage section
Battery is stored here.
Open the cover to
connect a connector.
*2 Connect a power supply of 100-240 V AC (+10%, -15%) 50/60 Hz.
Do not connect any power supply other than the above, otherwise it may cause malfunction.
*3 The memory card should stay inserted in the product all the time.
Removing it while the power is on or the card is being accessed may cause the product to malfunction.
Before removing the card from the memory card slot, make sure to hold the RESET switch in the "SEL."
position and to turn the power off after the "CF CARD" LED goes out.
Incorrect procedure might cause data logging failure or equipment failure. Please consider UPS if the
power failure is frequently occurred.
Power supply
terminal block
Connect to
power supply. (*2)
11
Front
(with the server section cover opened)
Memory card
EJECT button
Push the button to eject the
memory card.
MODE switch
Set it to the RUN position for
normal operation.
RESET switch
Use to reset the product.
Memory card
Programs for collecting and
displaying data are stored
in this card.
It is also used to save
collected data.
(*3)