Led Indicators - D-Link DGS-3130-30TS Hardware Installation Manual

DGS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
Feature
Jumbo Frame Size
Switching Capacity
Maximum Packet Forwarding Rate
Priority Queues
MAC Address Table
IP Routing Tables
Virtual Stacking / Clustering

LED Indicators

Location LED
Per Device Power
MGMT
Console
Fan Err
RPS
USB
Stacking ID
(7-segment LED)
Description
9K Bytes (9216 Bytes)
DGS-3130-30TS: 168 Gbps
DGS-3130-30S: 168 Gbps
DGS-3130-30PS: 168 Gbps
DGS-3130-54TS: 216 Gbps
DGS-3130-54S: 216 Gbps
DGS-3130-54PS: 216 Gbps
DGS-3130-30TS: 125 Mpps
DGS-3130-30S: 125 Mpps
DGS-3130-30PS: 125 Mpps
DGS-3130-54TS: 161 Mpps
DGS-3130-54S: 161 Mpps
DGS-3130-54PS: 161 Mpps
8 Priority Queues per port.
Supports 16K (16,384) MAC addresses
IPv4: Max. 512 entries
IPv6: Max. 512 entries
Supports D-Link Single IP Management version 1.61
Manages up to 32 devices in a virtual stack with a single IP address
Color Status
Green Light on (Solid)
Off Light off
Green Light on (Solid)
Light blinking
Off Light off
Green Light on (Solid)
Off Light off
Red Light on (Solid)
Off Light off
Green Light on (Solid)
Light off
Green Light on (Solid)
Light blinking
Red Light on (Solid)
Off Light off
Green Light on (1-9)
Light on (H)
Light on (h)
Light on (E)
59
Description
Power on
Power off
Link present. No data transmission
Activity. Data transmission
No link present or the port was shutdown
RJ45 console port is active
Console off
Fan fail
Operating normally
RPS in use
RPS off
USB plugged in
Busy reading/writing
Read/Write failure
No USB plugged in
Stacking number displayed
Stacking Master
Stacking Backup Master
System self-test error