Hardware Components; Dgs-3130-30Ts Switch; Front Panel Components; Led Indicators - D-Link DGS-3130-30TS Hardware Installation Manual

DGS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide

2. Hardware Components

This chapter describes the front, rear, and side panel components of all switches in the series.

DGS-3130-30TS Switch

DGS-3130-30S Switch
DGS-3130-30PS Switch
DGS-3130-54TS Switch
DGS-3130-54S Switch
DGS-3130-54PS Switch
DGS-3130-30TS Switch

Front Panel Components

The front panel of DGS-3130-30TS features a variety of LED indicators and ports.
Ports that can be found on the front panel of this switch are listed in the table below.
Port
USB
MGMT
Console (RJ45)
10/100/1000 Mbps RJ45
Ports
10 Gigabit RJ45 Ports
10 Gigabit SFP+ Ports
For a complete list of SFP/SFP+ transceivers that are compatible with this switch, refer to the SFP Ports and SFP+
Ports sections in Appendix A - Technical Specifications.

LED Indicators

Located on the front panel of this switch are LED indicators: Power, Console, RPS, Fan Err, USB, Link/Act indicators
for all the ports, and Stack ID.
Figure 2-1 Front panel view of the DGS-3130-30TS
Description
Inserting a flash drive into the USB 2.0 Type-A port provides an additional storage
space for portable firmware images and configuration files that can be copied to
and from the NVRAM of the Switch.
The RJ45 Management (MGMT) port is an IP-based, Out-Of-Band (OOB) port for
Telnet, web, or SNMP management that operates at 10/100/1000 Mbps wire-
speed. This port can be used to configure the Switch without being connected to
the network.
The RJ45 console port can be used to connect to the Command Line Interface
(CLI) of the Switch for configuration, management, and monitoring. This port uses
a special console cable (included in this package) with a DB9 interface to connect
the Switch to the serial port (COM) of the PC.
The Switch is equipped with 24 RJ45 Ethernet ports. These ports can operate at 10
Mbps, 100 Mbps, and 1 Gbps wire-speeds.
The Switch is equipped with 2 RJ45 Ethernet ports. These ports can operate at 1
Gbps or 10 Gbps wire-speeds.
The Switch is equipped with 4 SFP+ ports. These ports can operate at 1 Gbps or
10 Gbps wire-speeds and support a wide collection of SFP+ transceivers.
11