Hyundai 1 inch Owner's Manual page 16

pre-inspection checks ensure the pump is on a level surface and the ignition
switch is in the 'OFF' position.
1) Routine Check
Check around and underneath the water pump for signs of oil or fuel leaks.
Remove any dirt or debris, especially from the engine muffler and recoil
starter.
Look for any signs of damage.
Check that all nuts, bolts, screws, hose connectors and clamps are tightened.
2) Check the Suction and Discharge Hoses
Check the general condition of the hoses. Before connecting the hoses to the
water pump, make sure that they are in good condition.
Remember that the suction hose must be of a reinforced construction to
prevent the hose from collapsing.
Check that the sealing washer in the suction hose connector is in good
condition. If there are any leaks or a poor connection, the pump will draw in air
and will not function.
Check that the hose connectors and clamps are securely installed.
Check that the strainer is in good condition and is secured on the suction hose.
3) Check Engine Oil
Place the engine on a level surface before checking the engine oil.
1. Remove the oil filler cap and wipe the dipstick clean.
2. The oil level should be at the top of the filler neck.
3. If the oil level is low, add the recommended oil to bring the level to the
top of the filler neck.
4. After adding the oil, remember to refit and screw down the oil dipstick.
P a g e | 16