Superior BRT2032TMN Installation And Operation Instructions Manual page 13

IHP recommends that a black iron gas line be routed from the gas
source, through a sediment trap (shown in Figure 16), and into ap-
pliance. Once connected through appliance, a flexible gas line may
be used for ease of installation to gas control valve (see Figure 17).
Typical Exterior
Wall Gas Shutoff
Installation
Key
Figure 14 - Manual Shutoff Valve Installation
1/2" NPT Incoming
Black Iron Gas Line
8 / "
3
7"
8
7"
Alternate Gas Supply
Through Sub-Floor
Figure 15 - Routing Incoming Gas Line
Gas Shutoff
Valve
1/2" NPT
Incoming
Gas Line
126745-01E
FIREPLACE INSTALLATION
Shutoff Valve
Extension
Flexible
Gas Line
(1 Provided)
Can Be
Extended Out
Either Side
10 /
5
Flexible Gas Line
Do NOT Kink
NOTE:
1) Wire Connections
Not Shown for Clarity
2) * 1/8" NPT Plugged
Tapping
Figure 17 - Connecting Flexible Gas Line to Millivolt Valve
SuperiorFireplaces.us.com
Continued
Sediment
Trap (Not
Supplied)
Before connecting the black iron gas line to the inside of the appliance
a sediment trap must be included outside the appliance between the
gas line and the gas shutoff valve. It must extend down 3" beyond
the center of the pipe. Prepare incoming black iron gas line with
Teflon tape or pipe joint compound (Check with local building codes).
CAUTION: Compounds used on threaded joints of
gas piping shall be resistant to the action of Liquefied
Petroleum (LP or propane), and should be applied
lightly to ensure excess sealant does not enter the
gas line. Sealant should not be used on a flare fitting
WARNING: All gas piping and connections must
be tested for leaks after the installation is completed.
After ensuring that the gas valve is on, apply a non-
corrosive leak detection solution to all connections
and joints. If bubbles appear, leaks can be detected
"
8
and corrected.
Do not use an open flame for leak testing and do not
operate any appliance if a leak is detected.
Complete your gas installation by connecting incoming gas line
with flexible gas line. Secure tightly with wrench but DO NOT
OVERTIGHTEN.
Red Surface Indicates For
Propane/LP Use Only
ON
OFF
IN OUT
Inlet Pressure Tap
Incoming
1/2" Gas Line
Permitted by
Local Codes
3" Min.
(7.6 cm)
Figure 16 - Sediment Trap
Pilot Adjustment
Outlet
Pressure Tap
13