Deleting Paired Accessories; Changing The Ringtone And Volume; Setting The Notification Mode - CBA RA-4961Q Manual

Deleting Paired Accessories:

1. Enter programming mode by holding
down the channel select button until the
Channel 1 LED flashes on the channel
notification panel.
2. Press the channel select button to cycle
through channels until the desired
channel is selected.
3. Press and hold the channel select and
tone select buttons simultaneously until
a beep is heard and the channel LED
flashes. Press channel select button to
exit pairing mode. If no actions within
30 seconds, the receiver will
automatically exit the pairing mode.
Note: The reset button is used to reset a channel after it has been triggered. It is not used to
clear any programming.

Changing the Ringtone and Volume:

1. Enter programming mode by holding
down the channel select button until
the Channel 1 LED flashes on the
channel notification panel.
2. Press the channel select button to cycle
through channels until the desired
channel is selected.
3. Press the tone select button to cycle
through ringtones until the desired
ringtone is selected.
4. Press the channel select button to exit
programming mode.
5. To adjust volume, use a small
screwdriver to adjust the volume knob.

Setting the Notification Mode:

1. The wireless alert receiver has three modes – Audible
Alarm, Visual Alarm, and Audible and Visual Alarm.
2. When the Notification selection switch is flipped to
Audible Alarm the receiver speaker will sound and the
zone LED will light up.
3. When the switch is flipped to Audible and Visual Alarm
the receiver's speaker will sound, the notification LED
will light up, and the zone LED will light up.
4. When the switch is flipped to Visual Alarm the receiver's
notification LED will flash and the zone LED will light up.
SECO-LARM U.S.A., Inc.
CBA Wireless Alert System
Audible Alarm
Audible &
Visual Alarm
(Default)
Visual Alarm
Channel Tone
select
select
button
button
Volume
Channel
Tone
select
select
button button
7