Installing The Receiver; Installing The Pushbutton - CBA RA-4961Q Manual

Installing the Receiver:

1. Open the front cover of the receiver unit.
2. Determine how the receiver will be powered. Either insert three "C" batteries (observing correct
polarity, not included) or connect to 6VDC power supply (not included). Low battery is indicated
when the notification light flashes once every 5 seconds.
3. Program pushbutton and any other accessories (see Pairing Accessories pg. 6).
4. Receiver may either be placed on a table or other surface, or it may be mounted on a wall.
For Wall Mounting
1. Hold the receiver unit against the wall to get an idea of where the receiver should be installed.
2. Install 2 screws (not included) on the wall 2
3. Hang the receiver on the screws.
Receiver

Installing the Pushbutton:

1. Remove the front cover of the pushbutton by inserting a paperclip in the notch at the top of the
unit. Push down on the paperclip with force and pull the top of the front cover from the
pushbutton.
2. Mount the pushbutton to a wall or other surface using screws (not included) through the two
mounting holes.
3. Once the pushbutton has been mounted, snap the front cover onto the unit.
Insert paperclip
in notch
SECO-LARM U.S.A., Inc.
Table
Remove cover
CBA Wireless Alert System
5 / " (58mm) apart.
16
Receiver Wall
Mounting
holes
5