Table of Contents
Advertisement
CBA Wireless Alert System
Replacing the Pushbutton Battery:
1. Remove the front cover of the pushbutton by inserting a paperclip in the notch at the top of the
unit. Push down on the paperclip with force and pull the top of the front cover from the
pushbutton.
2. If there is a previous battery installed, use a fingernail or small object to remove the battery
from the battery holder.
3. Slide a CR2032 battery into the battery holder, making sure to observe correct polarity (positive
faces out).
4. Snap the front cover onto the pushbutton.
Insert paperclip
Note: Low battery for this and other accessories is shown on the receiver. When an accessory
battery is low, the zone LED for that accessory will blink continuously.
Pairing Accessories:
1. Enter programming mode by holding down the channel select button until the Channel 1 LED
flashes on the channel notification panel.
2. Press the channel select button to cycle through channels until the desired channel is selected.
3. Press the tone select button to cycle through ringtones until the desired ringtone is selected.
4. Trigger the pushbutton or other accessory. Once the accessory is triggered, the receiver will
beep indicating the units have been paired. If another channel lights up, this accessory is
already programmed on the indicated channel.
Note: If pairing an accessory to a channel that is already paired with another accessory, the
original paired accessory will be deleted.
5. Press the channel select button to move to the next channel or to exit paring mode.
Note: If no activity for 30 seconds the receiver will automatically exit pairing mode.
6
in notch
Remove cover
Channel
Tone
select
select
button
button
SECO-LARM U.S.A., Inc.
Battery
holder
Advertisement
Table of Contents
