Digital Video Reclocking DA
Trouble shooting
4
The Error and No I/P LEDs are lit
•
check that a serial digital video signal is connected to the rear connector input
BNC
The Error (No lock) LED is lit
•
check that the input signal is a valid serial digital video signal with a basic clock
rate of 143, 177, 270 or 360 Mbit/s.
Half the outputs appear not to work
•
check that only the non-inverting outputs (1 to 5) are used for ASI signals
The Power LED is not lit
•
check mains power to the frame is turned on
•
if necessary check the PSU as explained in the power supply section
•
check the card is plugged in securely
•
check to see if one of the re-setable fuses have operated. To do this turn the
power off, wait for thirty seconds and then restore the power.
Technical Manual
7