Maintenance And Repair Instructions; Edger Blade Replacement - Ryobi LE720r Operator's Manual

MAINTENANCE AND REPAIR INSTRUCTIONS

EDGER BLADE REPLACEMENT

WARNING: To avoid serious personal injury,
always wear gloves while handling, removing
or installing the blade.
WARNING: The gear housing gets hot
after long periods of use. To avoid serious
personal injury, do not touch the housing
until it has cooled.
1. Line up the hole in output shaft with the locking rod
slot. Insert the locking rod through the slot into the
output shaft hole (Fig. 7).
2. While holding the locking rod, loosen the nut on the
blade by turning it clockwise with a 5/8 inch wrench
(Fig. 8). Remove the nut, retaining washer and blade.
Keep the nut and blade retainer for installation.
3. Install the new blade, blade retainer, and nut
(Fig. 9). Insert the locking rod through the slot into
the output shaft hole. Make sure that the blade stays
flat and centered against the output shaft while
tightening the lock nut counterclockwise (Fig. 10).
4. If you have a torque wrench, tighten the nut to
325-335 in.•lbs (37-38 N•m), while holding the
locking rod in the slot.
If you do not have a torque wrench, hold the locking
rod in the slot. Rotate the nut counterclockwise
with a 5/8 inch closed-ended or socket wrench, until
the nut presses against the washer and the blade is
snug. Make sure the blade assembly is installed
correctly, then rotate the nut an additional 1/4-1/2
turn (Fig. 10).
5. Remove the locking rod.
WARNING: Verify the blade is flat against
the output shaft after the nut is tightened. If
the blade is off-center, the unit will be
damaged by vibration, and the blade may fly
off, which can cause serious personal injury.
Output Shaft
Hole
Locking Rod
Locking Rod
8
Output Shaft
Slot
Fig. 7
Fig. 8
Edger Blade
Fig. 9
Fig. 10
Loosen
Lock Nut
Blade Retainer
Locking Rod
Tighten