Bowers & Wilkins ISW-4 Owner's Manual
  1. Manuals
  2. Brands
  3. Bowers & Wilkins Manuals
  4. Subwoofer
  5. ISW-4
  6. Owner's manual
Bowers & Wilkins ISW-4 Owner's Manual

Bowers & Wilkins ISW-4 Owner's Manual

Custom installation series
Hide thumbs Also See for ISW-4:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual
Custom Installation Series
ISW-4
SA250
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ISW-4 and is the answer not in the manual?

Questions and answers

Related Manuals for Bowers & Wilkins ISW-4

Summary of Contents for Bowers & Wilkins ISW-4

  • Page 1 Custom Installation Series ISW-4 SA250 Owner’s Manual...
  • Page 2 Figure 1 Figure 2 Figure 3...
  • Page 3 Figure 4b Figure 4a Figure 5 SA250...
  • Page 4 Figure 6a Figure 6b Figure 7a...
  • Page 5 Figure 7b Figure 8 15mm (0.6in)
  • Page 6 Figure 9 SA250 Figure 10 Housing Insert Chuck Bushing Neutrik Speakon Connector ® ® NL4FC ISW-4 SA250 SA250 000-0000000 NL4FC ISW-4...
  • Page 7 Figure 11 NL4FC Subwoofer #1 Subwoofer #2 SA250 AC 230V ~ 50/60Hz POWER: 300W SA250 Serial No. 000-0000000 1. Ground 2. (+) 3. (-)

  • Page 8: Installation And Setup Manual

    English 17. The mains plug of the power supply cord shall remain readily operable. Installation and 18. Do not expose batteries to excessive heat such as sunshine, fire or the like. Setup Manual The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the Important Safety Instructions presence of uninsulated “dangerous...

  • Page 9: Environmental Information

    The product is shipped in three cartons: the ISW-4 frequency. Carton, the Back Box Carton and the SA250 Carton Using multiple subwoofers in a single installation can In addition to the Driver Panel, check the ISW-4 carton improve performance in the following ways: for: This manual •...
  • Page 10 Solid wall construction If the ISW-4 is to be installed in a solid wall the Back Stage 5: Fitting the Driver panel Box should be built in to the brick or block-work in With the Wall Frame secured and the wall decorated, a similar manner to a window frame.
  • Page 11 Two ISW-4 subwoofers can be connected to the amplifier through use of either the two pairs of binding 1 x Mains input socket: Connect mains power using posts or the supplied four-pole Speakon plug.

  • Page 12: Fine Tuning

    red) should be connected to the positive output Setting the LOW-PASS FREQ setting is irrelevant as terminals on the amplifier and the negative terminals the filter is switched OUT. on the subwoofer (marked – and coloured black) Set the EQUALISATION switch to MOVIE. connected to the negative output terminals on the See the “Fine Tuning”...

  • Page 13: All Applications

    power amplifier driving the other speakers happens to receive a 12V signal that will toggle the MOVIE/MUSIC invert the signal, the 180° position may be preferable. setting at the front panel. Set appropriately, the 12V Listen with the switch in both positions and choose trigger output of a processor can automate ideal the one that gives the fullest sound.

This manual is also suitable for:

Sa250

Table of Contents