Quick Start - Siemens Gigaset 2420 System User Manual

capacity decreases over time, shouldn't we recommend several discharge/charge cycles to rejuvenate them? JIM
McDermott
7. The charger cradle has a separate battery charger compartment in the back. You can purchase two spare AA
8. Do not put nonrechargeable batteries in the spare compartment. When
you replace the cordless handset's batteries 'with the spare batteries, replace both batteries.
To charge extra batteries, slide the battery charger compartment's cover up and off the charger. Place the batteries inside the
charger compartment and slide the cover back into the charger. See illustration below.
6 These batteries need to be charged for at least ~2 hours 18-20 before being used. The "R" on the left icon on the charger
cradle stands for "Reserve." The light under this icon indicates whether the batteries in the spare compartment are being
charged. Itshould be on.
9. Slide the belt clip onto the back of the cordless handset. Snap the pins on the inside of the belt clip 5 arms into the holes
near the handset's earpiece.

Quick Start

The first things you may need to do
after you charge the cordless handset's batteries are:
Register a cordless
handset to the desk
station
Deregister a cordless
handset from the desk
Understand how to find
and change options
Adjust the contrast of your
desk station display
Set the time and date (to
track answering system
messages)
• Installation
Chapter
Record announcements See Recording
for the answering system Announcement in Chapter 6 Answering System
Change the system's PIN See Change System PIN in (to prevent unauthorized Chapter 7 Customizing Your changes and for
remote System
access of answering system messages)
There are numerous other features you may wish to customize, depending on how you plan to use your phone system. Keep track
of customized settings in Appendix C Programming Worksheets.
To allow multiple systems with multiple cordless handsets to be installed near each other, each desk station must know which
handsets it should communicate with. This is called "Registration. The cordless handset cannot operate unless t is registered to a
desk station.
The cordless handset shipped with your system is registered at the factory to the accompanying desk station. If you purchased
additional handsets you will need to register them with a desk station
1. If the first display you
see has a flashing
"Searching" or a steady
"Please Register" on it,
you must register the
rechargeable NiCd batteries and store them in the charger compartment.
See below
See Base Settings in Chapter
7 Customizing Your System
See the cordless handset's
and the desk station's How
Menus Work sections in
Chapter 2 The Basics
See Display Contrast in
Chapter 7 Customizing Your
System
See the desk station's How
Menus Work section in
Chapter2 The Basics
station
7
Registration