Table of Contents
Advertisement
telephone jack on the bottom of the desk station labeled Lines 1 & 2 in the illustration on page 2.
b. Snap the other ends of the Y telephone line cord into the wall jacks.
Note: You may need to purchase additional supplies for
other configurations.
5.
Thread the long straight section of the coiled handset core into Cord Channel 4 and snap
the plug into the desk station.
6.
Snap the other end of the coiled handset cord into the desk station's handset (receiver).
7.
If you wish, you can connect your fax modem to the AUX PORT at the bottom of the desk station. Using this port rather
than having the Fax/modem connected directly to a phone line, provides two advantages:
• •
If you have two outside lines, the Fax/modem can use either line to place its call. See Automatic Line Seizure in
Chapter 7 Customizing Your System for more information about setting line access preferences.
• •
You can set the Distinctive Ringing feature described in Chapter 7 Customizing Your System so that the system will not
ring any of the phones when a Fax/modem call arrives.
If you want to connect a Fax/modem line to the desk station, snap one end of a telephone line cord (not provided) into the
Fax/modem or to a Fax/modem PC card. Thread the telephone line cord into Cord Channel 2 and snap the plug into the
AUX PORT jack located on the bottom of the desk station.
4
1.
Choose a location. Do not install the cordless handset charger cradle near microwave ovens, radio equipment, or non-cable
connected televisions. These appliances may cause electrical interference. For more information on appropriate locations,
see the Important Safety Instructions section in this manual.
The charger cradle can be installed on a flat surface or mounted on the wall. It must be connected to an AC power outlet.
See the User Guide for the Gigaset 2400CG found in the charger cradle box for more information.
Use within a temperature range of 32 to 120 F.
2.
Plug the charger cradle's power supply cord into a functional 11 0 volt electrical outlet.
3.
The cordless handset comes with two AA rechargeable NiCd batteries. Place these batteries into the cordless handset as
indicated by the illustration in the handset's battery compartment.
4.
Get the battery charger door cover from the accessory kit and position it as indicated in the illustration above Insert the
batteries and slide the cover forward into the grooves until it latches into the handset.
5.
Place the cordless handset into the charger cradle.
6.
Look at the battery charge icons ________ ________
charger cradle. The light under the icon on the right
Chapter • •
Installation
indicates whether the cordless handset's batteries are being charged. It should be on.
Note: The lights underneath the battery charge icons may turn off periodically during charging This is normal
Charge the batteries
until the battery charge icon in the
cordless handset's
display shows a full
charge. This will take approximately 12 hours. The batteries take less time to recharge. Is it a problem to leave the mobile in
the charger indefinitely? Does this decrease battery capacity? How do you tell when the batteries need to be replaced? If
Chapter • •
Installation
Cordless Handset/Charger Cradle
- R +
-
+
in the lower left corner of the
5
Hide quick links:
Advertisement
Table of Contents
