Poe - Pockethernet Manual

PoE

This test verifies the presence of a Power over Ethernet supply in mode A
(pairs 2+3/Endspan) or mode B (1+4/Midspan) and reports the voltage
measured. Additionally, voltages are also measured on each wire pair
separately (e.g. pins 1+2, 3+6,...) to detect the presence of analog phone
lines.
The PoE results - if present - are shown in the main summary line of the
measurement, the individual pairs in a table below.
Currently, it will detect voltages above 30V. It doesn't recognize passive PoE
that is below that. (e.g. 24V) The hardware is capable of this, but we need to
make some adjustments to the software to enable this feature. (We're
working on this 16/2/2017)
16