Power Button - Pockethernet Manual

(1) Power button

Use this button to switch the device on and off or reset it in case of software
failures.
Status Action
When the device is switched off, press it briefly to switch it on
On
When the device is powered on, press it for 3 seconds, until
Off
the device turns off
Should the device show symptoms of software failure (not
Reset
going through the measurement cycle, charging or
communicating with the smartphone application), you can
reset the device by pressing and holding the button for 10
seconds
Press the button two times quickly to turn on all wire pair
Flashlight
LEDs in a bright white light
To do a quick measurement without the smartphone
Quick
application connected, press the button briefly. Results are
measurement
shown on the wire pair status LEDs
10