Cleaning And Troubleshooting Your Waterpik® Water Flosser - Waterpik WP-861 User Manual

8
CLEANING AND TROUBLESHOOTING YOUR WATERPIK® WATER FLOSSER
Using Mouthwash and Other Solutions
Your Waterpik® Water Flosser can be used to deliver mouthwash and antibacterial
solutions. After using any special solution, rinse unit to prevent clogging by partially
filling reservoir with warm water and running unit with tip pointed into sink until
unit is empty.
Cleaning
Before cleaning, unplug from the electrical outlet. Clean the product when necessary
by using a soft cloth and mild non-abrasive cleanser. The reservoir is removable for
easy cleaning and is top rack dishwasher safe.
Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the mineral content
of your water. If left unattended, it can hinder performance. Cleaning internal
parts: add 2 tablespoons of white vinegar to a full reservoir of warm water. Point
the handle and tip into sink. Turn unit ON and run until reservoir is empty. Rinse by
repeating with a full reservoir of clean warm water.
This process should be done every 1 to 3 months to ensure optimal performance.
Leakage
If leaking due to a damaged hose, please email InternationalService@waterpik.com
Service Maintenance
Waterpik® Water Flossers have no consumer serviceable electrical items and do not
require routine service maintenance. For all accessories go to www.waterpik.com/intl.
Refer to the serial and model numbers in all correspondence. These numbers are located
on the bottom of your unit. Distributed By:
Church & Dwight (Australia) Pty. Ltd.
Level 2, 22 Rodborough Road,
Frenchs Forest NSW 2086
Email: enquiries@churchdwight.com.au
Freecall Australia: 1800 222 099
Freecall NZ: 0800 380 218