Assembly Of The Device To The Hot Tapping Valve; Installing The Feed Unit - Metabo BE 1100 Operating Manual

Jip hot tapping machine

Hide thumbs Also See for BE 1100:

Table of Contents

Operating Guide

4.2.4 Assembly of the Device to the Hot Tapping Valve

- The adapter has to be connected to the thread of the valve by

first winding with hand and tightening it tenderly using the wrench.

Because the tightening O-ring, it is not necessary to use much force

while connecting the parts.

- Prior connecting the adapter to the valve, a proper central drill,

hole saw, chuck and drill shaft have to be assembled together as

shown in chapter 4.2.1- 4.2.2.

- When all parts have been screwed on, test that it is still possible

close the valve as shown in the picture below ! Dismantle the

machine and adjust it again if the valve cannot be closed !

- Remember to FULLY open the valve after that !

- The feed device ⑦ is used to create a feed force for the drillling.

- The feed thread has to be winded to back position completely by

turning the feed wheel ⑧ counter-clockwise.

- The adjusting socket ⑨ shall be connected by first alignig the grooves

and the guide screws A and there after slided to the closest locking

groove B at the machine body.

- The excessive clearance is removed by turning the feed wheel ⑧

clockwise.

- Measure the feed distance as described in chapter 3.3 and adjust it by

shaft or feed extensions if possible.

JIP Hot Tapping Machine

⑦

VI.KD.G1.02 | 13

⑧

⑨

Table of Contents