Danfoss Jip Hot Tap Valves With Hot Tapping Machine - Metabo BE 1100 Operating Manual

Operating Guide

3.3 Danfoss JIP Hot Tap Valves with Hot tapping machine

Drilling device is used with Danfoss JIP Hot Tap Ball Valves in a range from DN20 to DN100 and in water based
heating and cooling systems. All other forms of this normal use shall be deemed to be contrary to the instructions.
A connection between the machine body and the valve is realized by threaded adapter pieces. Some adapter
pieces are used for more than one nominal size by using an reduction socket.
All adapters are designed to be used ONLY for Danfoss JIP Hot Tapping Valves. Keep in mind to control the allowed
pressure and temperature acc. chapter 3.1 and following Danfoss JIP Hot tap ball valves data sheet.
DN
mm
PN
Hole saw diameter
mm
Code No.
Tool box Code No.
Depending on the valve length the shaft has to be adjusted. The recommended way to find the correct shaft
lengths is shown in the pictures below.
- At first, push the shaft forward so that the pilot drill touches the pipe surface.
- Measure the lengths between the lower shoulder of the shaft and the upper device body.
- The measured distance should be between 100 - 170 mmn
- Adjust the length of the shaft if necessary as shown in chapter 4.2.1 and 4.2.2
The feeding distance is recommended to
be at least 35 mm.
8 | VI.KD.G1.02
JIP Hot Tapping Machine
JIP Adapter <= DN50
20 25
Ø15 Ø24
065N0106 065N0111 065N0116
065N1003
JIP Adapter >= DN65
JIP Adapter Socket
32 40 50
40
Ø24 Ø40 Ø40
065N0121 065N0126
065N1002
65 80
25
Ø48 Ø65
065N0131 065N0136 065N0141
065N1004
© Danfoss | 2017.06
100
Ø79