WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1
Place the power-supply unit on the chassis, aligning the screw holes on the power-supply unit to the screw holes on the chassis.
2
Replace the four screws (#6-32x6.35) that secure the power-supply unit to the chassis.
3
Route the power-supply unit cable (ATX SYS) through the routing guide on the chassis.
4
Connect the power-supply unit cable (P1) to the system board (ATX SYS).
5
Connect the power-supply unit cable (P2) to the processor-power cable (ATX CPU).
Post-requisites
Replace the
computer
cover.
Replacing the power-supply unit
computer. After working inside your computer, follow the instructions in
After working inside
www.dell.com/
Replacing the power-supply unit
21
37