Date/Time - Tripp Lite B022-U08-IP Owner's Manual

7. Administration
2. Fill in the form with the appropriate information for your company. The table below is an example of a filled out form.
Field
Country (2 letter code)
State or Province
Locality
Organization
Unit
Common Name
Email Address
3. When all fields have been filled out (all fields are required), click the Create button.
4. Click the Get CSR button, and then save the certificate file to a convenient location on your computer. This is the file that you give to
the third party CA to apply for their signed SSL certificate.
5. After you have received the certificate from the third party CA, save it to a convenient location on your computer. In the Certificate
Signing Request section of the Security page, click the Browse button and navigate to and select the certificate.
6. Click the Upload button.
Note: When uploading the file, the KVM checks to make sure the specified information still matches. If it does, the file is accepted. If it does not
match, the file will be rejected. If you want to remove the certificate (e.g. to replace it with a new one because of a domain name change), click the
Remove CSR button.

7.2.17 Date/Time

The Date/Time page allows the user to set the date and time
parameters for the KVM switch. The following section describes
the settings on this page.
( continued )
Example
TW
Taiwan
Taipei
Your Company, Ltd.
Techdoc Department
www.mycompany.com Note: This entry must be the exact domain name of the site that you want the certificate to be
valid for. If the site's domain name is www.mycompany.com, and you enter mycompany.com, the certificate will not
be valid.
administrator@yourcompany.com
Time Zone
• Select the Time Zone and City that most closely resembles
where the KVM switch is in using the drop-down menu at the
top of this section.
• If your area uses Daylight Savings Time, check the Daylight
Savings Time checkbox.
To manually set the date and time, do the following:
1. In the Date section, select the current month using the drop-
down menu.
2. If needed, click the < or > buttons in the Date section to
move backward or forward to the correct year.
3. In the calendar in the Date section, click on the current day.
4. In the Time section, enter in the current time using the 24 hour
HH:MM:SS format.
5. Click the Set button in the Time section to apply your changes.
Network Time
To have the time automatically synchronized to a network time
server, do the following:
1. Check the Enable Auto Adjustment checkbox.
2. Select a time server from the Preferred Time Server drop-down
list; or, check the Preferred Custom Server IP checkbox and
enter in the IP of your preferred time server.
3. If desired, repeat step two to enter an Alternate Time Server.
4. Key in the desired number of days between synchronization in
the Adjust Time Every __ Days field.
5. Click the Adjust Time Now button to synchronize immediately.
58