Using The Microphone - Sennheiser e 614 Instruction Manual

Using the microphone

Positioning the microphone
Drums / Percussions
Pos.
In order to prevent interference due to crosstalk between adjacent
sound sources, try to position the microphone so that the interfering
sound source is located in the angle area of the highest cancellation of
the microphone (approx. 135°; see polar diagram)
Cleaning and maintaining the e 614
Caution
Unscrew the sound inlet basket
X
Remove the foam insert from the sound inlet basket
X
Use a slightly damp cloth to clean the sound inlet basket
X
the inside and ouside.
Reinsert the foam insert into the sound inlet basket
X
the sound inlet basket on the microphone and screw it tight.
e614_511652_0117_SP9.indb 3
Resulting sound
B.1 • Natural, clear
sound
B.2 • More fundamental,
little overtones
Liquids can damage the electronics of the product!
Liquids entering the housing of the product can cause
a short-circuit and damage the electronics.
Keep all liquids away from the product.
X
Do not use any solvents or cleansing agents.
X
B
Commentary
Position the microphone a few
centimetres above the outer edge
of the hi-hat aiming down. If
necessary, remove unwanted low-
frequency signal portions by high
pass filtering.
Attention: When closing the hi-
hat, a strong air current is created
on the edge. If the microphone is
positioned too close to the edge,
interfering noise due to the air
current can occur.
1 .
1 .
1 from
1 and replace
3
05.01.2017 14:24:17