Table of Contents
Advertisement
USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
MODE
Press to switch the air cooler between FAN only, COOL and WARM only modes.
FAN - The unit is automatically set to the Fan only mode when first switched on. No indicator lights
will illuminate in this mode. The unit will operate without any humidification or heating function. Only
fan speed can be adjusted in this mode.
COOL - Press the MODE button until the COOL indicator light is illuminated on the control panel.
This activates evaporative cooling. The water pump will operate and you will feel the cooler air after
the Honeycomb Cooling Media is completely wet. Both fan SPEED and HUMIDITY level can be
adjusted in this mode. It is recommended to put the fan speed on HIGH until the area is initially
cooled, then switch to the desired fan speed.
WARM - Press the MODE button until the WARM indicator light illuminates. In this mode the unit
produces warm air only. Fan SPEED, HEATING level can be adjusted in this mode by pressing the
corresponding buttons.
HEATING
When WARM mode has been selected, the HUM indicator light will illuminate. The unit will expel
warm and moisturized air simultaneously. Press the HEATING button to select LOW or HIGH warmth
level.
SPEED
Press the SPEED button repeatedly to change the speed between HIGH - MED - LOW - SLEEP.
The indicator light will show the selected speed:
Sleep(SLEEP)
High(HIGH)
Medium (MED)
Low(LOW)
SWING
Press the SWING button once to turn the swing function and LED indicator will
illuminate. The louvers will swing from left to right. Press this button again to stop the
swinging louvers and the LED indicator will switch off.
LOUVER
MOVEMENT
EN
3
Advertisement
Table of Contents
