Table of Contents
Advertisement
USE & OPERATION (CONTINUED)
REMOTE CONTROL
ON / OFF
HEATING
MODE
TIMER
SWING
SPEED
NOTE:
•
The remote control requires two AAA (2 x 1.5V) batteries for replacement. Open the battery
•
compartment at the back of the remote control and insert the batteries inside. Care must be
taken to insert the batteries according to the correct polarity (+ / –) markings shown inside the
battery compartment.
•
Always point the remote control signal transmitter towards the unit when operating. Make sure
that the signal path is not obstructed.
•
Remove the batteries if the unit is not going to be used for an extended period of time.
•
Do not drop the remote control.
•
Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
•
Do not mix old and new batteries.
•
Do not recharge the battery.
•
Exhausted batteries are to be removed from the product and safely disposed of as per local
regulations.
•
Do not dispose of batteries in fire. Batteries may explode or leak.
WARNING: Caution for ingestion of the small battery. Keep away from children and animals.
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product. Please
refer to the COOLER LOCATION section of the separate Safety & Maintenance Guide.
POWER
:
ON / OFF
MODE
:
Controls COOL / WARM / FAN Modes
HEATING
:
Select HIGH / LOW heat in WARM mode
SPEED
:
Low / Medium / High / Sleep
SWING
:
Switch on / off automatic louvers
TIMER
:
Controls the Timer function for automatic off
EN
4
Advertisement
Table of Contents
