Table of Contents
Advertisement
FINE (Analog input only)
Improve focus, clarity and image stability by increasing or decreasing this setting.
If the "Auto Adjust" function and the "H.SIZE" function do not give you a satisfactory picture setting, fine tuning can be
performed by using the "FINE" function.
A Moiré test pattern can be used for this. If the Fine value is incorrectly calibrated, the result would look like the left
drawing. The image should be homogeneous.
INPUT RESOLUTION (Analog input only)
Selects one of the following pair of resolutions as the input signal priority:
1360 x 768 or 1280 x 768 or 1024 x 768 (vertical resolution 768),
1600 x 900 or 1280 x 960 (horizontal frequency 60kHz),
1680 x 1050 or 1400 x 1050 (vertical resolution 1050).
VIDEO LEVEL (HDMI input only)
NORMAL: For computer setting. Displays all input signals of 0-255 steps.
EXPAND: For audio-visual equipment setting. Expands input signals of 16-235 steps to 0-255 steps.
OVER SCAN (HDMI input only)
Some video formats may require different scanning modes in order to best display the image.
ON: Image size is larger than what can be displayed. The image edge will appear cropped. Approximately 95% of the
image will be shown on the screen.
OFF: Image size stays within the display area. The whole image is displayed on the screen.
EXPANSION
Sets the Zoom method.
FULL: The image is expanded to full screen regardless of the resolution.
ASPECT: The image is expanded without changing the aspect ratio.
Color
Color Control System: Color presets are available for adjusting color settings. (sRGB and NATIVE color presets are
standard and cannot be changed).
1, 2, 3, sRGB, 5: Increases or decreases Red, Green or Blue color depending upon which is selected. The change
in color will appear on screen and the direction (increase or decrease) will be shown by the bars. sRGB mode
dramatically improves the color fidelity in the desktop environment by a single standard RGB color space. With this
color-supported environment, the operator could easily and confidently communicate color without further color
management overhead in most common situations.
NATIVE: LCD panel's original colors that cannot be adjusted.
L/B (LOW BLUE LIGHT): Reduces blue light emitted from monitor.
NOTE: You can directly change to L/B (LOW BLUE LIGHT) mode by touching the SELECT key for 3 seconds
or more. For changing to other settings from L/B mode, touch the INPUT key to show OSD menu and
enter COLOR control.
When L/B is selected in COLOR control, CONTRAST and DV MODE are disabled.
DICOM SIM.: The white point color temperature and the gamma curve are set to a DICOM simulation.
PROGRAMMABLE: The gamma curve is adjustable through application software.
NOTE: When MOVIE, GAMING, or PHOTO is selected as the DV MODE, NATIVE is selected automatically
and cannot be changed.
When FINE value is
wrong.
English-16
When FINE value is
correct.
Advertisement
Table of Contents
