Troubleshooting - Workzone Q1W-SP14-1900A Original Operating Instructions

• Place the protective cap onto the threaded connector in order to avoid dirt and
damage.
•
Wind the power cord onto the cord bracket (4).
• Secure the end of the cord with the cord clamp, as shown in figure.
If the machine is not going to be used for a lengthy period of time, empty the
detergent tank and drain the water out of the hoses.
Store the machine upright in a dry, frost-free, well ventilated place, out of the reach
of children.
Transport
Where possible, use the original packaging for transport.
+44 (0) 190 472 7501
AFTER SALES SUPPORT GB
+353 (0) 19022605
IRE
22
www.coreservice.co.uk
Q1W-SP14-1900A

Troubleshooting

WARNING
Do not make any attempt to repair the machine yourself. You can put your
life at risk through electrocution, and this can cause damage to the machine
and invalidate your warranty.
The table below is a useful point of reference if malfunctions occur.
Troubleshooting table
Fault Cause
-
Power supply
interrupted
Not functioning
- Machine switched off
- Defective components,
e.g. switches, motor
-
Power cord damaged
-
Internal electrical
Machine works connection has
with interruptions come loose
-
ON/OFF switch
defective
- Air in the system, needs
to be vented
-
No or inadequate water
No or minimal
intake
build-up of
pressure
- Clogged dirt filter
-
Spray lance set to low
pressure
- Machine draws in air
+44 (0) 190 472 7501
AFTER SALES SUPPORT GB
+353 (0) 19022605
IRE
8
Solution
-
Check the power connection,
cord and fuse; if necessary, have
them repaired by an electrician
- Activate the ON/OFF switch
- Consult Customer Service
-
Consult Customer Service
- Operate the machine without the
high-pressure hose connected
until the water emerges clear of
bubbles. Attach the hose again.
-
Check / open the intake valve
- Check the intake hose for leaks or
blockages
- Check and clean the filter
-
Check the spray lance setting
- Check the intake hose for leaks
23
www.coreservice.co.uk Q1W-SP14-1900A