Troubleshooting - Workzone HCE2000 User Manual

HCE2000
Cleaning
It is recommended to clean the high pressure washer after each use.
Never direct the water jet against the high pressure washer, nor clean the
high pressure washer under flowing water. This could give rise to the danger
of electric shock and damage the high pressure washer!
Always keep the high pressure washer clean. Do not use any detergents or solvents.
• Always keep the ventilation slots clean and free from dirt and dust.
• Only clean the high pressure washer with a soft brush or a slightly moist cloth.
• If nozzles are soiled or blocked, you can remove any foreign bodies in the nozzle
using the nozzle cleaning needle (13).
Maintenance
The high pressure washer is maintenance free.
XI. Troubleshooting
Problem Possible Cause
No electrical voltage to the high
pressure washer.
The cross section of the extension
The high pres-
cable is not large enough and/or
sure washer
the extension cable is too long.
does not work.
The mains voltage is lower than
that specified.
The high pressure washer is
frozen.
The motor
Air intake in the water inlet.
starts but there
is no pressure
build-up.
Water cock closed.
Air intake in the water inlet.
The operating
pressure is
irregular.
Nozzle is clogged.
AFTER SALES SUPPORT
1300 855 831

Maintenance and Cleaning/Troubleshooting
MODEL: HCE2000 PRODUCT CODE: 10490 09/2019
Action
Check the fuse, power cable
and power plug and have
them replaced by qualified
personnel if necessary.
Use extension cables with
larger cross sections and/or
use shorter extension cables.
Contact the power supply
company if necessary.
Check and thaw if necessary.
Check the supply hose and
hose connectors and replace
if necessary.
Turn open the water cock.
Check the supply hose and
hose connectors and replace
if necessary.
Open nozzle with the nozzle
cleaning needle (13).
 support@scheppach.com.au
AUS
23