Workzone Q1W-SP14-1900A Original Operating Instructions page 10

•
Pull the nozzle head forward to lower the pressure and push the nozzle head back to
raise the pressure. (Figure 15)
By turning the nozzle head through 180°, you can adjust the width of the jet from
spot jet to flat jet:
• Turn the nozzle head counterclockwise to set a spot jet. The further you turn the
nozzle head in a clockwise direction, the wider the flat jet becomes. (Figure 16)
NOTE
The spot jet is especially suitable for cleaning very soiled, narrow places,
whereas the flat jet is ideal for cleaning wide areas.
Using the turbo lance
The turbo lance (9) creates a rotating jet of water which can be used to remove
stubborn dirt.
ATTENTION
When you use the turbo lance, there is a very great risk of damaging sensitive
surfaces. Apply it carefully, starting off with a large working distance and
reducing it as required.
• Stop the machine and switch the ON/OFF switch to OFF.
• Press the trigger on the spray gun briefly to reduce the system pressure.
•
Insert the turbo lance instead of the spray lance. (Figure 4)
Using the rotating brush
The rotating brush (8) is a tool for cleaning surfaces with care. The brush is driven here
by the high-pressure jet, and the water only strikes the surface being cleaned at low
pressure.
The cleaning effect is achieved by the action of the brush, and the loosened dirt is
washed away by the water.
• Stop the machine and switch the ON/OFF switch to OFF.
• Press the trigger on the spray gun briefly to reduce the system pressure.
•
Insert the rotating brush instead of the spray lance or the turbo lance.
(Figure 5)
+44 (0) 190 472 7501
AFTER SALES SUPPORT GB
+353 (0) 19022605
IRE
18
www.coreservice.co.uk
Q1W-SP14-1900A
Automatic feed of detergents
WARNING
Only use the detergents supplied or recommended by the manufacturer.
The safety of the machine may be adversely affected if you use other
detergents or chemicals.
Following direct contact between the detergent and your skin or mucous
membrane, rinse with lots of clear water and seek medical attention,
if necessary.
This high-pressure washer is equipped with a device for automatically feeding
detergents to the jet of water. Procedure for using this function:
•
Lock the trigger on the spray gun by flipping the yellow safety catch up until it
becomes engaged. (Figure 13)
• Remove the sealing cap from the detergent tank (1) on the back of the machine and
pull the hose out. (Figure 14)
• Take the detergent tank off the bracket and fill it with detergent.
•
Place the detergent tank back onto the bracket, reinsert the hose and replace the
sealing cap.
• Fit the adjustable spray lance (10) onto the spray gun.
• Set the nozzle head to the low pressure position by pulling it forward. (Figure 15)
•
Disengage the safety catch and press the trigger on the spray gun to start work.
+44 (0) 190 472 7501
AFTER SALES SUPPORT GB
+353 (0) 19022605
IRE
19
www.coreservice.co.uk Q1W-SP14-1900A