Assembly - Ryobi RY60512 Operator's Manual

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Cultivator
Drag Bar
Pull Pin
Hitch Pins (2)
Felt Washers (2)
Inner Tines (2)
Outer Tines (2)
Ryobi Exact Mix 2-Cycle Oil
Wheel Assembly (Accessory)
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Failure to heed
this warning could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.

ASSEMBLY

WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
POSITIONING THE HANDLEBAR
See Figure 2.
 Loosen the two handlebar knobs.
 Unfold the handlebar into operating position.
NOTE: Do not use force. If there is binding, continue to
loosen the knobs. Do not allow throttle cable to become
pinched when raising the handlebar.
 Retighten the handlebar knobs.
HANDLEBAR
8
HANDLEBAR
KNOBS
Fig. 2