Adjusting The Nailing Depth - Makita XNB02 Instruction Manual

Intermittent nailing (sequential mode)
This mode suits for driving a nail carefully and accurately.
Continuous/ intermittent nailing (continuous mode)
When the tool is set to this mode, you can choose either
continuous or intermittent nailing by sequences of the
trigger operation.

Adjusting the nailing depth

WARNING:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before adjusting the depth of nailing.
Turn the adjuster to adjust the nailing depth. The nailing
depth gets deeper as you turn the adjuster to A direc-
tion, shallower to B direction in the figure. The range of
the nailing depth adjustment is 3 mm.
► 1. Adjuster
NOTICE:
Do not turn the adjuster too much, or
the adjuster may get stuck.
Adjust the nailing depth as necessary.
1
► 1. Too deep 2. Flush 3. Too shallow
Lighting up the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger or actuate the contact element to
light up the lamp. The lamp keeps on lighting while pull-
ing the switch trigger or actuating the contact element.
The lamp goes out approximately 10 seconds after
releasing the switch trigger and the contact element.
1
A
B
2 3
► 1. Lamp
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: The nailer may not fire nails even if the lamp
lights up because the remaining battery power is low.
In this case, charge the battery cartridge.
ASSEMBLY
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before carrying out any work on the
nailer.
Loading or unloading the nails
CAUTION:
Always make sure that the battery
cartridge is removed before loading the nails.
Unintentional firing may cause personal injuries and
property damage.
CAUTION:
Do not abruptly slide the pusher
lever on the magazine loaded with nails.
Accidentally dropping nails especially when working
in high places may cause personal injuries.
CAUTION:
Load the nails in the correct direc-
tion. Loading in wrong direction may cause prema-
ture wear and tear of the driver and damage of the
other parts.
CAUTION:
Do not use deformed connected
nails. Use nails specified in this manual. Using nails
other than those specified may cause the nail jam-
ming and breakage of the nailer.
1. Remove the battery cartridge.
2. Pull the pusher lever down ward until it locks with
a little click.
7 ENGLISH
1