ISLABIKES Creig Owner's Manual page 11

User guidelines
Your Creig has been designed to be ridden on rough trails,
rough unpaved roads and rough terrain that require technical
skill. Jumps and drops are intended to be less than 61cm
(24inches). The maximum safe combined rider and luggage
weight limits are as follows:
• Creig 24 = 121Ibs
• Creig 26 = 143Ibs
It is not possible to make a bike that is never going to be
damaged in an accident. If your child uses their bike beyond
its limitations, there is a high risk of failure which could result
in serious injury or death. Bikes that are used competitively
should be subject to more frequent and rigorous checks. Take
particular care to check the frame tube junctions and welds
as well as all the components for damage or excessive wear.
If in any doubt, please contact our technical support team at
503 954 2410 or support@islabikes.com or take it to a
qualifi ed bicycle mechanic for inspection.
Please note your bike is not intended for the following types
of riding:
• Dirt jumping
• BMX
• Four-cross
Creig 24 / Creig 26
• Downhill
• Slalom
Step 6 of 6
Brake pad bed-in
It is important to bed-in your new brake pads to achieve optimal
performance, increase pad longevity and reduce the likelihood of
brake fade and noise.
To safely achieve optimal results, remain seated on the bike during
the entire bed-in procedure. Accelerate the bike to a moderate speed
(12mph / 20kph), then fi rmly apply the brakes until you are at walking
speed. Repeat approximately twenty times. Next, accelerate the bike
to a faster speed (20mph/30kpm), then fi rmly apply the brakes until
you are at a walking speed. Repeat approximately ten times.
Important: do not lock up the wheels at any point during the bed-in
procedure. Allow the brakes to cool prior to any additional riding. If you
require further information about your brakes, contact our technical
support team at 503 954 2410 or email support@islabikes.com
E-mail: support@islabikes.com Telephone: 503 954 2410