Operation - Mira REALM Installation And User Manual

OPERATION

This thermostatic shower control has a single sequential lever. The shower control
is turned on by turning the control lever anti-clockwise. The shower control is
turned off by turning the control lever clockwise. When the control lever is turned
on (anti-clockwise) the sequence is:
Cold water Warm water Pre-set maximum temperature.
Initial anti-clockwise movement turns the water on at full flow of cold water, further
anti-clockwise movement increases the temperature. The flow rate is determined by
the supply pressures at the inlets of the shower control, or by the effective output
power of the heater appliance. Flow rates for gas water heaters and combination
boilers can vary typically between 8 L/min (winter) and 15 L/min (summer).
Warning! For safety reasons this product incorporates a maximum temperature
setting. This setting must be checked and adjusted as necessary to suit both site
conditions and user's comfort. Refer to the section: 'Commissioning, Maximum
Temperature Setting'.
15