Care And Maintenance; Maintenace Schedule; Wiring Harness And Hand Control; Lift Platform/Metal Components - Pride Backpacker AVP 2.0 Owner's Manual

V I . C A R E A N D M A I N T E N A N C E

CARE AND MAINTENANCE

Your lift system requires a minimal amount of care and maintenance. If you do not feel confident in
your ability to perform the maintenance listed below, you may schedule inspection and maintenance
at your authorized Pride Provider. The following areas require periodic inspection and/or care and
maintenance. Failure to perform the required maintenance procedures at the required intervals may
void your warranty.

Wiring Harness and Hand Control

■ The wiring harness should be checked periodically for corrosion and/or decay. Contact your
authorized Pride Provider if the wiring harness needs to be replaced.
■ Avoid leaving the hand control in areas where it will be exposed to inclement weather or temperature
extremes. Exposure to the elements may cause damage to the hand control.
PROHIBITED! Avoid exposure to rain, snow, salt, or standing water whenever possible. Maintain and
store in a clean and dry condition.

Lift Platform/Metal Components

■ Check the lift platform for wear or damage. Contact your authorized Pride Provider for repair or
replacement.
■ The lift platform surface may become slippery if exposed to moisture (ice, snow, rain, mist/spray
conditions, etc.). Use caution when loading/unloading a mobility device in these conditions and wipe
off any excess moisture from the lift platform.
■ Regularly inspect the metal lift components for scratches. Treat any problem areas with a rust
inhibitor or metal sealant.
MAINTENANCE SCHEDULE
Perform prior to daily use
■ Inspect all external electrical connectors for damage and replace if necessary.
■ Check for damaged or loose hardware. Tighten or replace if necessary.
Perform every 6 months:
■ Inspect all mounting hardware for defects and a secure fit. Any loose hardware should be tightened
or replaced if necessary.
■ Remove and inspect the pivot bolts on the parallel arms and lubricate or replace as necessary.
NOTE: Use only "petroleum-based anti-seize lubricant."
Perform every 6 – 12 months:
■ Lubricate chains with "general purpose petroleum-based grease."
■ Lubricate the truck drive shaft with "petroleum-based anti-seize lubricant" only.
■ Inspect the base rollers and replace as necessary.
■ If base rollers were replaced, readjust the elevator bolt for proper alignment of parallel arms.
■ Inspect chain for proper tension and adjust as necessary.
NOTE: The chain should have a 1/2 in. (1.27 cm) of deflection in either direction when the truck
is fully extended contacting the front microswitch.
Backpacker Series www.pridemobility.com 21