Backpacker Avp Platform Adjustment; Wheel Chock Installation - Pride Backpacker AVP 2.0 Owner's Manual

Backpacker AVP platform adjustment

The Backpacker AVP is equipped with an adjustment
platform that can be lengthened or shortened to
accommodate a wide range of mobility devices. See
figure 5.
Follow these steps to adjust the platform:
1. Remove the nuts and bolts that secure the adjustable
wings to the main platform.
2. Move the adjustable wings to the desired width.
3. Align the adjustment holes of the wings with the
holes of the main platform.
4. Reinstall the nuts and bolts, and tighten.

Wheel Chock Installation

Your lift is supplied with two adjustable wheel chocks
that aid in centering your mobility device during loading.
See figure 6 or 7.
Follow these steps to adjust the wheel chocks:
1. Remove the wheel chocks.
2. Drive your mobility device onto the lift platform, positioning it as near to the center as possible.
3. Position the wheel chocks on the platform. Scooters: Place a wheel chock in front of the front
wheel(s) and behind the rear wheels or behind the front wheel(s) and in front of the rear wheels.
Power Chairs: Place a wheel chock in front of the drive wheels and behind the drive wheels.
4. Take note of the adjustment holes the wheel chocks align with on the platform and remove the
chocks.
NOTE: For larger scooters, the wheel chocks may be positioned to the inside of each wheel.
5. Remove the mobility device from the lift platform.
6. Raise the platform high enough to be able to install hardware from beneath it.
7. Place the wheel chocks onto the lift platform and secure them with the supplied bolts and nuts.
NOTE: Make sure the mobility device is properly secured with the Y-strap before operating the
lift or transporting the mobility device.
12
I I I . I N S TA L L AT I O N
www.pridemobility.com
Figure 5. Backpacker AVP Platform Adjustment
ADJUSTABLE
WING
BOLT
NUT
BOLT
NUT
Backpacker Series