Raise Or Lower The Tower Arm; Front-To-Back Movement; Manual Adjustment Wrench - Pride Backpacker AVP 2.0 Owner's Manual

To operate the manual override:
1. Secure the appropriate end of the flex-shaft to a drill, and depending on which part of the lift you
want to move, attach the appropriate hardware to the other end of the flex-shaft. See figures
11, 12 13, and 14.
2. Insert the flex-shaft into the appropriate adjustment opening of the lift.
3. Operate the drill to ensure the lift is moving in the desired direction. Change the spin direction of the
drill if needed.
4. Operate the drill until the lift reaches the desired position.
NOTE: When a power drill is not available, the manual adjustment wrench can be used. See
figure 15. Attach the small opening of the manual adjustment wrench to the flex-shaft or hex
hardware and rotate manually in the direction in which you want the lift to move.
TOWER ARM
Figure 13. Raise or Lower the Tower Arm
HARDWARE
*Either of the two wrenches may come with your lift. They perform the same function.
Figure 15. Manual Adjustment Wrench
Backpacker Series
I V. O P E R AT I O N
HARDWARE
www.pridemobility.com
Figure 14. Front-to-Back Movement
HARDWARE
17