Advertisement
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
- Disassembly Heater assy.
Remove the base by unscrewing the 4 Torx screws.
Disconnect the wires that are connected to the heater assy.
Remove the Cir clip that fi xes the heater assy.
Open the lid and gently push (force maybe needed) on the
inside of the heater.
The heater and Gasket will move out of the Kettle body.
Remove the Gasket from the heater.
- Re-assembly the heater assy.
Place the gasket on the heater assy. (see picture for
placement details.)
Don't forget to place the 2 fi lter stands (specifi c left and
right depended) in the housing. (see pictures for details)
Make the outside of the gasket and the inside of the Kettle
housing were the gasket will be placed wet with plain water.
Gently push the heater assy with gasket equable in the
Kettle body.
PARTS LIST
Pos
Service code
1*
9965 000 30285
2
9965 000 30286
3
9965 000 30287
4
9965 000 32709
5
4222 459 45068
* Standardized part
Description
Switch actuator Assy
Filter assy HD4983
Rubber foot set (3pcs)
CS7 connector
Lid assembly
Sunfl ower orange
While pushing inwards check if the gasket keeps well
around the heater assy.
The heater assy and gasket has to be pushed over the ridge.
Check visual if the gasket is correct placed.
Reassembly the Cir clip for fi xation of the heater assy.
By fi lling the kettle with plain water and leave it for half an
hour, you can check if the gasket properly sealed the Kettle.
Connect the wires again.
Fix the base again.
Check the functions of the Kettle.
REPAIR INSTRUCTION
- Electrical circuit
When the appliance does not work, check the electrical
Circuit.
- De-scaling
Fill the kettle with water up to three-quarters of the
maximum level indication and press the on/off switch.
After the kettle has switched itself off, add white vinegar
(8% acetic acid) or an appropriate descaler up to the
maximum level indication.
Leave the solution in the kettle overnight.
Empty the kettle and rinse the inside thoroughly.
Repeat this procedure if there is still some scale left in the
kettle.
- Cleaning filter
Clean the fi lter by rinsing it under a running tap.
If necessary, you can use a soft nylon brush.
The scale fi lter can also be cleaned in the dishwasher or
clean the fi lter by de-scaling it in the same way as the kettle.
Let the fi lter soak in a cup of warm water with some white
vinegar or an appropriate descaler.
Take the fi lter out of the cup and rinse it thoroughly.
OPTIONAL (accessories)
Commercial trade number
- Double action Filter : HD4983 (White)
Pos
Service code
Description
6
9965 000 30289
Steam switch
7
9965 000 38977
Heater assy HV 220-240V/2400W
8
9965 000 30291
Sealing ring
9
9965 000 30292
Cir -Clip
10
4222 459 45069
Base
HD4680/55
Bright white
2-3
Advertisement
