Runco Video Xtreme VX-2i Owner's Operating Manual page 48

Operation
HD Format: If for some reason the VX-2i does not properly detect the incoming signal
format (color space) on the HD1 or HD2 inputs, specify it here (RGB or YUV). Otherwise,
leave it set to Auto.
Triggers: Select Triggers from the Service menu to configure the 12-volt trigger outputs.
You can assign one or more trigger outputs to each aspect ratio. Those triggers are then
activated by selecting that aspect ratio.
If your projector is equipped with the Runco CineWide with AutoScope system, assign at
least one trigger output (the same one to which the lens motor is connected) to the
Cinema and Virtualwide 2.35 aspect ratios.
Miscellaneous: Select Miscellaneous from the Service menu to set the following options:
• Menu Mode: This is the manner in which the OSD menus appear and disappear when
you press MENU. Choose one of the following:
0 = No transition; menus abruptly appear and disappear.
1 = Menus fade in and out.
2 = "Checkerboard" dissolve; menus appear and disappear in sections.
3 = "Window shade" effect; menus are drawn on a diagonal from top left to bottom
right, and retract in the opposite direction.
• Timeout - Short/Long: These settings control how long the OSD menus stay on
screen. Select a time-out period of from 2 to 60 seconds.
• Side Bar Color: This controls the color of the inactive image area. The range is from
-100 (black) to 100 (white).
The inactive image area is on either side of the active image area when using the
Standard 4:3 aspect ratio, and above and below the active image area when using the
Letterbox aspect ratio.
System Reset: To reset ALL projector settings (including image settings) back to their
factory defaults, choose System Reset from the Service menu. Select Confirm to continue
or Back to cancel. This action is not undoable. Use it with caution!
38 Runco VX-2i Owner's Operating Manual