Isf Presets; Information; Calibration - Runco Video Xtreme VX-2i Owner's Operating Manual

Operation

ISF Presets

ISF Presets
ISF Night
ISF Day
Custom 1
Custom 2
Factory Default

Information

Information
Serial Number
Hardware
Firmware
Date

Calibration

Calibration
ISF Night
Display Color
Input Image
Input Color
ISF Day
Display Color
Input Image
Input Color
Overscan: Image Overscan pushes the outside edge of the active picture area of the
video signal out beyond the edge of the display area.
Some television programs are produced based on the assumption that older television
sets may not display the outer edges of the broadcast picture area. Over scan effectively
trims away these inactive, outer edges and enlarges the remaining portion of the image to
fill the display area.
Select from 1% to 10% of Overscan, as desired.
For HDTV, DVDs and other video sources, Overscan is generally not necessary or
desirable.
For each input, the VX-2i lets you save image quality settings as presets that you can
recall at a later time. You can create up to four presets per input and resolution. Use the
ISF Presets menu to recall saved image presets, or to save image settings in the "Custom
1" or "Custom 2" memory location. The currently-selected preset is indicated by a "
its left; in the example shown here, ISF Night is selected.
You should save changes to any of the following settings to a preset; otherwise they will
Save
be lost when a new input source or resolution is selected:
Save • Aspect ratio
• Picture quality settings (brightness, contrast, color saturation, tint and sharpness)
• Input position (image position, width, height and overscan percentage)
To reset all image presets to their factory defaults, select Factory Default and press
ENTER.
Select Information from the Main Menu to see information that uniquely identifies your
projector: its serial number, the installed hardware and firmware versions and the firmware
version build date. Should you ever need to contact Runco Technical Support, this
information will help them answer your questions or resolve product performance issues.
Use the Calibration menu to perform advanced picture quality adjustments. This menu
should be used by ISF-certified technicians only.
Note
The changes you make here take effect immediately; you do not need to save them. To
recall the ISF Night or ISF Day settings, select "ISF Night" or "ISF Day" from the ISF
Presets menu (see above).
You must enter a passcode to access the Calibration menu.
34 Runco VX-2i Owner's Operating Manual
" to