System Exclusive Message; System Realtime Message - Roland FP-5 Manual

Reset All Controllers (Controller number 121)
Status 2nd byte
BnH 79H
n = MIDI channel number: 0H - FH (ch.1 - 16)
When this message is received, the following controllers will be set to their reset values.
Controller Reset value
Pitch Bend Change ?0 (center)
Channel Pressure 0 (off)
Modulation 0 (off)
Breath Type 0 (min)
Expression 127 (max)
Hold 1 0 (off)
Sostenuto 0 (off)
Soft 0 (off)
Hold 2 0 (off)
RPN unset; previously set data will not change
NRPN unset; previously set data will not change
All Notes Off (Controller number 123)
Status 2nd byte
BnH 7BH
n = MIDI channel number: 0H - FH (ch.1 - 16)
* This MIDI message will change on GM2 Tones only.
When All Notes Off is received, all notes on the corresponding channel will be turned off.
However, if Hold 1 or Sostenuto is ON, the sound will be continued until these are turned
off.
OMNI OFF (Controller number 124)
Status 2nd byte
BnH 7CH
n = MIDI channel number: 0H - FH (ch.1 - 16)
The same processing will be carried out as when All Notes Off is received.
OMNI ON (Controller number 125)
Status 2nd byte
BnH 7DH
n = MIDI channel number: 0H - FH (ch.1 - 16)
The same processing will be carried out as when All Notes Off is received. OMNI ON will
not be turned on.
MONO (Controller number 126)
Status 2nd byte
BnH 7EH
n = MIDI channel number : 0H - FH (ch.1 - 16)
mm = mono number : 00H - 10H (0 - 16)
* This MIDI message will change on GM2 Tones only.
* The same processing will be carried out as when All Notes Off is received.
POLY (Controller number 127)
Status 2nd byte
BnH 7FH
n = MIDI channel number: 0H - FH (ch.1 - 16)
* The same processing will be carried out as when All Notes Off is received.

System Realtime Message

Active Sensing
Status
FEH
* When Active Sensing is received, the unit will begin monitoring the intervals of all
further messages. While monitoring, if the interval between messages exceeds 420 ms,
the same processing will be carried out as when All Sounds Off, All Notes Off and Reset
All Controllers are received, and message interval monitoring will be halted.
3rd byte
00H
3rd byte
00H
3rd byte
00H
3rd byte
00H
3rd byte
mmH
3rd byte
00H

System Exclusive Message

Status Data byte
F0H iiH, ddH, ......,eeH
F0H: System Exclusive Message status
ii = ID number: an ID number (manufacturer ID) to indicate the manufacturer whose
Exclusive message this is. Roland's manufacturer ID is 41H.
ID numbers 7EH and 7FH are extensions of the MIDI standard;
Universal Non-realtime Messages (7EH) and Universal Realtime Messages (7FH).
dd,...,ee = data: 00H - 7FH (0 - 127)
F7H: EOX (End Of Exclusive)
Of the System Exclusive messages received by this device, the Universal Non-realtime
messages and the Universal Realtime messages and the Data Set (DT1) messages will be set
automatically.
Universal Non-realtime System Exclusive Messages
Identity Request Message
Status Data byte
F0H 7EH, 10H, 06H, 01H
Byte Explanation
F0H Exclusive status
7EH ID number (Universal Non-realtime Message)
10H Device ID (10H or 7FH)
06H Sub ID#1 (General Information)
01H Sub ID#2 (Identity Request)
F7H EOX (End Of Exclusive)
When this message is received, Identity Reply message (p. ??) will be transmitted.
GM1 System On
Status Data byte
F0H 7EH, 7FH, 09H, 01H
Byte Explanation
F0H Exclusive status
7EH ID number (Universal Non-realtime Message)
7FH Device ID (Broadcast)
09H Sub ID#1 (General MIDI Message)
01H Sub ID#2 (General MIDI 1 On)
F7H EOX (End Of Exclusive)
* There must be an interval of at least 50 ms between this message and the next message.
GM2 System On
Status Data byte
F0H 7EH 7FH 09H 03H
Byte Explanation
F0H Exclusive status
7EH ID number (Universal Non-realtime Message)
7FH Device ID (Broadcast)
09H Sub ID#1 (General MIDI Message)
03H Sub ID#2 (General MIDI 2 On)
F7H EOX (End Of Exclusive)
* There must be an interval of at least 50 ms between this message and the next message.
GM System Off
* "GM System Off" is a command message that resets the internal state of the FP-5.
Status Data byte
F0H 7EH, 7F, 09H, 02H
Byte Explanation
F0H Exclusive status
7EH ID number (Universal Non-realtime Message)
7FH Device ID (Broadcast)
09H Sub ID#1 (General MIDI Message)
02H Sub ID#2 (General MIDI Off)
F7H EOX (End Of Exclusive)
Status
F7H
Status
F7H
Status
F7H
Status
F7H
Status
F7H
5