Configuring Dmp 128 Plus C V (At) Voip Lines; Network Interface Configuration - Extron electronics DMP 128 Plus C V Configuration Manual

Ringcentral configuration guide digital matrix processors

Hide thumbs Also See for DMP 128 Plus C V:

Table of Contents

Revision Date: 06/26/18

DMP 128 Plus C V / C V AT – RingCentral

3.0 Configuring DMP 128 Plus C V (AT) VoIP Lines

VoIP configuration of the DMP 128 Plus is handled exclusively through a web interface, served

from the device itself. The VoIP landing page is accessed through an address of the format -

http://192.168.254.254/www/voip.html

- where 192.168.254.254 in this example is the default IP address of the DMP 128 Plus device.

Up to 8 lines may be configured. Note that each line intended for use will require a unique

Extension to be specified as part of the IP Office configuration process.

Click on the Network tab followed by Interface tab to set up the desired network interface on

the DMP 128 Plus; either LAN1 or LAN2 may be used for VoIP. VLAN tagging is available on

either interface if required. Up to two DNS entries may be manually specified.

Click Apply after making any changes in order to restart the networking services on the device.

Page 5 of 14

Table of Contents

Do you have a question about the DMP 128 Plus C V and is the answer not in the manual?

Dmp 128 plus c v at