Yamaha FZS1000 2003 Supplementary Service Manual page 13

E Route the throttle position sensor lead inward the
EXUP cable.
F Clamp the Al system hose and carburetor heater
hose with a plastic clamp.
G Route the carburetor heater hose inside the EXUP
cable.
H Route the carburetor heater hose between frame
and radiator fan motor lead.
I Route the carburetor heater hose over the frame.
J Clamp the right handlebar switch lead to the frame
with a plastic clamp.
K Align the taping section of the right handlebar switch
lead with the weld beads of tank rail and clamp with
the throttle cables 1 and 2. Point the tip of clamp to
the downward outside of the vehicle.
L To the carburetor.
CABLE ROUTING
M Fasten the radiator hose with a plastic band.
N Fasten the pickup coil lead with a steel clamp.
O Route the coolant reservoir tank over flow hose, fuel
tank drain hose and fuel tank breather hose through
the frame hose holder from the inside of the vehicle
to the outside. At this time, pull the fuel tank drain
hose and fuel tank breather hose so that the white
paint marks are within a 20 mm range.
P Route the EXUP cable forward the another hoses,
and upward the engine mounting bracket.
Q Fasten the rear brake light switch lead with a plastic
guide.
R Route the rear brake light switch lead inside the
another leads.
S Insert the all couplers into the rubber cover.
–5–
SPEC