Axis Q1615–E Mk II User Manual page 10

AXIS Q1615–E Mk II Network Camera
Setup
A capture mode consists of a resolution and the corresponding frame rate available in the product. The capture mode setting
affects the camera's field of view and aspect ratio.
The lower resolution capture mode is cropped out from the highest resolution.
The image shows how the field of view and aspect ratio can change between two different capture modes.
How to select capture mode
Which capture mode to choose depends on the requirements of frame rate and resolution for the specific surveillance setup. For
specifications about available capture modes, see the product's datasheet. To find the latest version of the datasheet, go to axis.com
How to replace the lens
1. Stop all recordings and disconnect power from the product.
2. Disconnect the lens cable and remove the standard lens.
3. Attach the new lens and connect the lens cable.
4. Reconnect the power.
5. Go to the Image tab in the product's webpage and select the P-Iris lens you have installed.
Note
If you use a DC iris lens, select Generic DC Iris.
6. Go to System > Maintenance and click Restart to restart the device and for changes to take effect.
7. Adjust the zoom and focus.
How to select exposure mode
There are different exposure mode options in the camera that adjusts aperture, shutter speed, and gain to improve image quality for
specific surveillance scenes. Go to Settings > Image > Exposure and select between the following exposure modes:
• For most use cases, select Automatic exposure.
• For environments with certain artificial lighting, for example fluorescent lighting, select Flicker-free.
Select the same frequency as the power line frequency.
• For environments with certain artificial light and bright light, for example outdoors with fluorescent lighting at night and
sun during daytime, select Flicker-reduced.
10