Undo R & B Convergence Mid; Green Convergence Mid; Undo Green Convergence Mid; Common Settings - Runco DTV-940 Owner's Operating Manual

Undo R & B convergence mid
When "R & B convergence mid" is selected, all convergence settings are set to
their midposition. To cancel this action, select 'Undo R & B convergence mid'by
pushing the control disc up or down and press ENTER. 'Undo R & B convergence
mid' is displayed in the Memory management menu instead of 'R & B conver-
gence mid'when this latter is pressed.
An undo is possible as long as the projector is playing on the same source (= same
adjustment block) even when some adjustments are already readjusted. When undo
is pressed all settings are reset to the previous settings.

Green convergence mid

Only available when the projector is equipped with green convergence adjust-
ments.
Highlight 'Gr convergence mid'by pushing the control disc up or down and press
ENTER to switch off the green convergence.

Undo green convergence mid

Only available when the projector is equipped with green convergence adjustment.
The item 'Undo green convergence mid'will automatically be displayed when the
green convergence is switched to midposition.
Press ENTER to switch on the green convergence.

Common Settings

Highlight 'Common settings' by pushing the control disc up or down and press
ENTER to display the common settings menu.
Within the common settings menu, the following items can be set up or executed :
- G2 adjustment
- CRT run in cycle
- Projector warm up
- Memorybanks
7-8