Table of Contents
Advertisement
Available languages
Available languages
Wall-Mounted Wire Rope Winch SW W-SGG
English
with enclosed worm gear pair
Operating failures and their causes
failure
In unloaded state, it is
difficult to turn the
crank.
Load is not held
Load is not held, crank
rotates in reverse
Load is not held,
stopper does not
engage (no noise
during lifting)
1)
for example by Pfaff-silberblau service department.
Disposal
After placing out of service, the parts of the hand winch have to be recycled or
disposed according to legal regulations!
design changes under reserve
cause
Lubricant in bearing
points and gearing is
missing.
Winch was distorted
during mounting.
Load too light
Wrong coiling of the
rope winding.
Direction for lifting was
not correct.
Stopper blocked
Pressure spring defective
F04.02.063
Execute maintenance procedures
Check the fixing. Is the mounting surface even, are the screws
tightened correctly?
Make the load heavier (
minimum load see technical data)
Lay the rope correctly
Repair only by authorised expert
• Unscrew and remove locking screw (1)
• pull out of housing
• Check and if necessary replace release
spring and mushroom head rivet
• Check stopper (visible from upper side)
for free movement and release if
necessary by slightly striking against the
stopper
• Re-assembly by reverse order
Function check
elimination
1)
page 12
1
Advertisement
Table of Contents
