Mitsubishi Electric Melsec iQ-R60AD8-G User Manual page 30

When the connector/terminal block converter module is used
The A/D converter module allows the use of the connector/terminal block converter module and the dedicated cables that are
designed for the Q68AD-G.
To use the connector/terminal block converter module, wire the module as shown below.
*1 Be sure to use a shielded cable. The shield must be grounded.
Product name
Connector/terminal block converter module
Dedicated cable
In the factory default settings of the modules, or the R60AD8-G and R60AD16-G, the offset/gain setting is
configured with the module being independent.
For this reason, the use of the connector/terminal block converter module and the dedicated cables may
cause an error in conversion characteristics due to the effect of conductor resistance and other factors.
If this effect is a problem, use the user range setting to set the offset and gain values.
For the offset/gain setting, refer to the following.
Page 35 OFFSET/GAIN SETTING
6 WIRING
28
6.2 External Wiring
Connector/terminal block
converter module
CH1 V+
CH1 V-
*1
Model
FA1-TBS40ADGN
FA-LTB40ADGN
FA-CBL05Q68ADGN
FA-CBL10Q68ADGN
FA-CBL20Q68ADGN
FA-CBL30Q68ADGN
Dedicated cable
*1
Shield
Remarks Contact

Your local Mitsubishi Electric sales office or
representative

Cable length 0.5m
Cable length 1.0m
Cable length 2.0m
Cable length 3.0m