Advertisement
Install Febreze® Filter
WARNING
Before using your vacuum, make sure that the dirt tank is in locked position and that the
filter is in place. DO NOT operate your vacuum without the filter.
1
2
To access the filter, twist
Press top of Dirt Tank
the top of tank counter-
to release it from the
clockwise to unlock and
vacuum base.
reveal filter.
NOTE: Your vacuum comes with a standard foam filter (yellow) located in the top of of the
dirt tank. A separate Febreze® foam filter (black) may also be packed in the box. Both are
washable. Over time, the Febreze® filter will begin to lose scent after use and washing.
Power On & Settings
1
Bare Floor Setting -
For bare floors or low
pile carpet.
High Carpet Setting -
For high pile and most
shag carpet
Turn the dial on the foot of the vacuum to desired
setting. If dial is difficult to turn, tilt vacuum back.
Above Floor Cleaning
1
Pull hose up and out of
vacuum base to attach
your desired tool.
Febreze® and related trademarks are owned by the Procter & Gamble Company,
Cincinnati, Ohio and used under license by BISSELL Homecare, Inc.
6
www.BISSELL.com
*
*Included separately
3
Replace standard yellow
foam filter with Febreze®
black foam filter to freshen
as you vacuum.
2
Press down once on the red ON/
OFF pedal located on the lower
back of the vacuum to turn ON.
Press down again to turn OFF.
2
For extended reach, attach the
Extension Wand to the hose first
and then your desired tool.
Empty Dirt Tank
WARNING
To reduce the risk of electrical shock, turn power switch off and disconnect polarized plug
from electrical outlet before performing maintenance or troubleshooting checks.
1
2
Press the release button
at the top of the tank to
Empty once tank is full.
remove it from the vacuum.
Clean Tank & Cyclone
1
Remove the Dirt
Tank and twist
its top counter-
clockwise to
unlock and pull
up to separate.
3
4
Place the top back on
Align tabs on Cyclone
the Dirt Tank by aligning
assembly with tank to
the tab, then twist
replace.
clockwise to lock.
NOTE: Let parts dry completely before returning them to vacuum for use.
3
Hold dirt tank over a trash
tank and press lid release
button to empty. Close lid and
return tank to vacuum base.
2
Grab the top of the Cyclone
assembly to remove. Clean
with warm water and mild
detergent. Wipe inside of
tank with a damp cloth.
Do not reassemble until
completely dry.
5
click
Return the fully-assembled
tank to the vacuum base
and press firmly until you
hear a "click."
www.BISSELL.com
7
Advertisement
