Cooktop Installation - Wolf CT30I/S Instructions Manual

Installation Information
COOKTOP INSTALLATION
Attach the foam strip to the underside of the cooktop frame. Gently lower the cooktop into the cut-out area in the
counter top and center. Check that the front edge of the cooktop is parallel to the front edge of the counter top.
Check that all required clearances are met.
Attach the brackets to the bottom of the unit, as shown in the illustration below. Install the clamping screws into the
bracket and tighten until the screws contact the underside of the counter top. Do not over-tighten the screws (See
Figure 2-3).
NOTE: Do not seal the cooktop to the counter top. The cooktop must be removable if service is necessary.
IF THE CERAMIC GLASS TOP OF COOKTOP IS BROKEN, TURN OFF POWER TO UNIT. DO NOT OPERATE
UNTIL GLASS HAS BEEN REPLACED BY A WOLF AUTHORIZED SERVICE CENTER.
#821684 - Revision B - March, 2013
Induction Cooktop (CTI) Series
Induction Cooktop (CTI) Series
Cooktop
Cooktop
Countertop
Bracket
Bracket
3-1/2" (89)
Screws
Clamping
Screw
Figure 2-3. Cooktop Installation.
2-10
Foam
Strip